Displaying Rip Settings; Resetting And Disabling Rip; Configuring Ospf - Extreme Networks 200 Series Installation And User Manual

Interior Gateway Routing Protocols

Displaying RIP Settings

To display settings for RIP, use the commands listed in Table 64.
Table 64: RIP Show Commands
Command
show rip {detail}
show rip stat {detail}
show rip stat vlan <name>
show rip vlan <name>

Resetting and Disabling RIP

To return RIP settings to their defaults, or to disable RIP, use the commands listed in Table 65.
Table 65: RIP Reset and Disable Commands
Command
config rip delete [vlan <name> | all]
disable rip
disable rip aggregation
disable rip export [static | direct | ospf |
ospf-intra | ospf-inter | ospf-extern1 |
ospf-extern2] metric <metric> {tag
<number>}
disable rip originate-default
disable rip poisonreverse
disable rip splithorizon
disable rip triggerupdates
unconfig rip {vlan <name>}

Configuring OSPF

Each switch that is configured to run OSPF must have a unique router ID. It is recommended that you
manually set the router ID of the switches participating in OSPF, instead of having the switch
automatically choose its router ID based on the highest interface IP address. Not performing this
configuration in larger, dynamic environments could result in an older link state database remaining in
use.
220
Description
Displays RIP configuration and statistics for
all VLANs.
Displays RIP-specific statistics for all VLANs.
Displays RIP-specific statistics for a VLAN.
Displays RIP configuration and statistics for
a VLAN.
Description
Disables RIP on an IP interface. When RIP is
disabled on the interface, the parameters are not
reset to their defaults.
Disables RIP.
Disables the RIP aggregation of subnet
information on a RIP v2 interface.
Disables the distribution of non-RIP routes into
the RIP domain.
Disables the advertisement of a default route.
Disables poison reverse.
Disables split horizon.
Disables triggered updates.
Resets all RIP parameters to match the default
VLAN. Does not change the enable/disable state
of the RIP settings. If no VLAN is specified, all
VLANs are reset.
Summit 200 Series Switch Installation and User Guide