Running Features On A Stack; Testing Images For A Stack - Extreme Networks 200 Series Installation And User Manual

Table 72: Stack Configuration Commands (continued)
Command
reboot slot <n>
show stack
show stacking
unconfigure slot <n>
unconfigure stacking
unconfigure switch all
use image [primary | secondary] [slot <n> | all]

Running Features on a Stack

To find information on how a particular feature implements stacking, see the description of the feature
in this manual.

Testing Images for a Stack

You can download and test an image on a single slot before attempting to download the image to every
switch in a stack. Enter the following commands to download an image to a slot:
use image [primary | secondary] [slot <n>]|[all]
download image <hostname/ipaddress> <filename> [primary | secondary] slot <n>
|all
reboot slot <n>
Where:
slot <n>
hostname
ipaddress
filename
primary
secondary
Be sure that you keep the same image versions on both the stack master and on the stack members. A
warning to syslog results when the versions do not match.
Summit 200 Series Switch Installation and User Guide
Description
Reboots a specific slot in a stack. Valid entries
are between 1 and 8.
Displays the local switch type on member
switches.
Displays the current state of stacking as well
as ports configured as stacking ports on each
switch in the stack.
Erases the configuration for a slot. The initial
use-image configuration is read from the
member's database.
Reboots the member switches and to revert
the members to their previously selected
configuration.
Reboots all of the member switches and clear
their configuration in the master switch.
Specifies that the stack is to use either the
primary or secondary image.
Is the slot to receive the download
Is the hostname of the server
I
s the IP address of the server
Is the filename of the new image
Indicates the primary image
Indicates the secondary image
Testing Images for a Stack
245