Commands For Configuring And Monitoring Eaps - Extreme Networks 200 Series Installation And User Manual

Ethernet Automatic Protection Switching
ring-connecting nodes. However, having EAPSv2 running on the node that interconnects the
rings will prevent problems with super-loops without requiring STP. This configuration process is
described in the EAPS chapter of the ExtremeWare Software User Guide, Version 7.1.0.

Commands for Configuring and Monitoring EAPS

Table 36 lists the ExtremeWare EAPS commands. Each command is described in detail in the sections
that follow.
Table 36: EAPS Commands
Command
config eaps <name> mode [master | transit]
config eaps <name> [hellotime <seconds> |
failtime <seconds>]
config eaps <name> [primary | secondary]
port <port number>
config eaps <name> [add | delete]
control vlan <name>
config eaps <name> [add | delete]
protect vlan <name>
config eaps <old_name> name <new_name> Renames an existing EAPS domain.
create eaps <name>
delete eaps <name>
disable eaps
disable eaps <name>
enable eaps
enable eaps <name>
show eaps {<name>} [detail]
unconfig eaps <name> [primary | secondary]
port
148
Description
Configures the switch as either the EAPS master
node or as an EAPS transit node for the
specified domain.
Configures the values of the polling timers the
master node uses for the EAPS health-check
packet that is circulated around the ring for the
specified EAPS domain.
Configures a node port as the primary or
secondary port for the specified EAPS domain.
Adds the specified control VLAN to the specified
EAPS domain, or deletes the specified control
VLAN from the specified EAPS domain.
Adds the specified protected VLAN to the
specified EAPS domain, or deletes the specified
protected VLAN from the specified EAPS domain.
Creates an EAPS domain with the specified
name. Only a singe domain is supported on this
platform.
Deletes the specified EAPS domain.
Disables the EAPS function for an entire switch.
Disables the EAPS domain with the specified
name.
Enables the EAPS function for an entire switch.
Enables the EAPS domain with the specified
name.
Displays EAPS status information. Use the
optional domain name parameter to display
status information for a specific EAPS domain.
Sets the specified port's internal configuration
state to INVALID, causing the port to appear in
the state Idle with a port status of Unknown when
you use the show eaps {<name>} detail
command to display port status information.
Summit 200 Series Switch Installation and User Guide