Extreme Networks 200 Series Installation And User Manual page 201

Table 56: Route Table Configuration Commands (continued)
Command
config iproute add default <gateway>
{<metric>}
config iproute delete <ipaddress> <mask>
<gateway>
config iproute delete blackhole <ipaddress>
<mask>
config iproute delete default <gateway>
config iproute priority [rip | bootp | icmp | static
| ospf-intra | ospf-inter | ospf-as-external |
ospf-extern1 | ospf-extern2] <priority>
disable iproute sharing
enable iproute sharing
rtlookup [<ipaddress> | <hostname>]
Table 57 describes the commands used to configure IP options and the ICMP protocol.
Table 57: ICMP Configuration Commands
Command
config irdp [multicast | broadcast]
config irdp <mininterval> <maxinterval>
<lifetime> <preference>
Summit 200 Series Switch Installation and User Guide
Description
Adds a default gateway to the routing table. A
default gateway must be located on a
configured IP interface. If no metric is
specified, the default metric of 1 is used. Use
the unicast-only or multicast-only options to
specify a particular traffic type. If not specified,
both unicast and multicast traffic uses the
default route.
Deletes a static address from the routing table.
Deletes a blackhole address from the routing
table.
Deletes a default gateway from the routing
table.
Changes the priority for all routes from a
particular route origin.
Disables load sharing for multiple routes.
Enables load sharing if multiple routes to the
same destination are available. Only paths with
the same lowest cost are shared. The default
setting is disabled.
Performs a look-up in the route table to
determine the best route to reach an IP
address.
Description
Configures the destination address of the
router advertisement messages. The default
setting is multicast.
Configures the router advertisement message
timers, using seconds. Specify:
• mininterval—The minimum amount of
time between router advertisements. The
default setting is 450 seconds.
• maxinterval—The maximum time
between router advertisements. The default
setting is 600 seconds.
• lifetime—The default setting is 1,800
seconds.
• preference—The preference level of the
router. An ICMP Router Discover Protocol
(IRDP) client always uses the router with
the highest preference level. Change this
setting to encourage or discourage the use
of this router. The default setting is 0.
IP Commands
199