Extreme Networks 200 Series Installation And User Manual page 223

Table 66 describes the commands used to configure OSPF.
Table 66: OSPF Configuration Commands
Command
config ospf add vlan <name> area <areaid>
link-type [auto | broadcast | point-to-point]
{passive}
config ospf vlan <name> neighbor add
<ipaddress>
config ospf vlan <name> neighbor delete
<ipaddress>
config ospf [area <areaid> | vlan [<name> | all]]
cost [automatic | <number>]
config ospf [vlan <name> | area <areaid> |
virtual-link <routerid> <areaid>] authentication
[simple-password <password> | md5
<md5_key_id> <md5_key>| none | encrypted
[simple-password <password> | md5
<md5_key_id> <md5_key>]
Summit 200 Series Switch Installation and User Guide
Description
Configures the OSPF link type. Specify one of
the following:
• auto—ExtremeWare automatically
determines the OSPF link type based on
the interface type.
• broadcast—Broadcast link, such as
Ethernet. Routers must elect a DR and a
BDR during synchronization.
• point-to-point—Point-to-point link type,
such as PPP.
The default setting is auto.
The passive parameter indicates that the
interface does not send or receive OSPF
packets.
Configures the IP address of a point-to-point
neighbor.
Deletes the IP address of a point-to-point
neighbor.
Configures the cost metric of one or all
VLAN(s). If an area is specified, the cost metric
is applied to all VLANs currently within that
area. When automatic is specified, the
advertised cost is determined from the OSPF
metric table and corresponds to the active
highest bandwidth port in the VLAN.
Specifies the authentication password (up to
eight characters) or Message Digest 5 (MD5)
key for one or all interfaces (VLANs) in an
area. The md5_key is a numeric value with the
range 0 to 65,536. When the OSPF area is
specified, authentication information is applied
to all OSPF interfaces within the area.
Configuring OSPF
221