Change Access Code For Pc-Communication (H8/S7) - Panasonic MEW01091 Operating Instructions Manual

Panasonic Electric Works Nordic AB
MEW01091
31.8
Action
"Access"
Scroll to menu S7
"A"
Rev: 3
Change access code for PC-
communication (H8/S7)
As a protection against unauthorised personnel programming the
system (via Win128), an access code 3B (for levels 3B and 4) for PC-
connection is required. For security reasons, the default code should
be changed.
NOTE! This code requires eight (8) digits.
Text in display
Acknowledge SERVICE signal
Change access code for PC-communication
Access code: _
New code: ********
Incorrect access code, NO change
Change access code for PC-communication
NOTE! After change of access code it is recommended do a "Safe
shutdown" of EBL128 (see menu H8/S4). This will save the SSW
data (e.g. the new code) in a Flash ROM (see page 74).
EBL128 Operating Instructions V1.1.x
ACCEPT? S1
ACCEPT? S7
Verify: ********
ACCEPT? S7
126
Comments
According to chapter
"Access code for service
and maintenance", see
page 118.
The digits are replaced
(********) in the display.
Wrong access code was
entered. Try again.
Correct access code was
entered. The access code is
now changed and the sub
menu H8/S7 is shown.
Scroll or press "Return" to
menu H8. Scroll or press
"Return" to log off.