Set Calendar And Clock (H3) - Panasonic MEW01091 Operating Instructions Manual

Panasonic Electric Works Nordic AB
MEW01091
26
Action
"Access"
Scroll to menu H3.
"A"
"A" or
"Return"
Rev: 3

Set calendar and clock (H3)

When required, the clock can be corrected, so that the "time stamps"
for fire alarms, faults, etc. will be correct.
The way the date is presented could be different for different
languages.
NOTE! The RTC component has no built-in battery, i.e. if EBL128 is
out of power (no mains and no battery backup), the date, day of the
week and the time have to be set when EBL128 is powered-up again.
In this menu is also the S/W (system program) version shown.
NOTE! The information shown in the display will be saved when
you press "A". If you don't want to change anything (e.g. if you
only want to see the S/W version), press "Return" instead of "A" to
return to menu H3.
Text in display
Set calendar and clock
Date: YY-MM-DD Time: hh:mm:ss
Weekday:W (1=M, 7=S)
NOTE! The date is in some conventions / languages shown
as DD-MM-YY.
Set calendar and clock
EBL128 Operating Instructions V1.1.x
ACCEPT? H3
VER:vvvvvvvvvvvv
ACCEPT? H3
93
Comments
According to chapter
"Access", see page 78.
Here is the S/W version
shown (e.g. VER: 1.1.0).
The time shown is the time
when "A" was pressed (in
menu H3).
When required, edit the
date, time and/or weekday.
Press "A". The "clock"
starts again from the date,
time, etc. shown in the
display.
NOTE! Press "Return"
(instead of "A") to return
to menu H3 if no changes
are to be done.
Scroll or press "Return" to
log off.