Executing Ykqrydev - HP XP P9500 Reference Manual

NOTE: Status displays the execution result of the action specified for AC. If you specify f for AC
and execute the action, out of the devices registered in the disk configuration definition file, all
command devices that are registered in the storage system are displayed in the Command Device
Selection List panel. If you press the F3=Exit key to exit the Command Device Selection List panel,
Status in the Route Status panel displays the processing result of a command device information
query (Fnd,nn).
You can use the SELECT command in the Route Status panel. For details about how to use the
SELECT command, see
You can specify the following fields as a condition of the SELECT command.
Name of field
DADID
LABEL
APID
SN
CU
CCA
DEVN
VOLSER
NOTE: If the field name is omitted, either of the following fields are set as the default:
In the Route Status panel displayed when the F10=DADInfo key is pressed: DADID
In the Route Status panel displayed when the F1 1=CCAInfo key is pressed: LABEL

Executing YKQRYDEV

When q is specified in the AC column in the Route Status panel, the YKQRYDEV command is
executed to display command device information. The Command Device Status panel will be
displayed. This panel will be also displayed when q is specified in the AC column in the Command
Device Selection List panel.
The Command Device Status panel is shown in
When registered to a storage system as a command device.
"Command Line Commands" (page
Value in field
Device Address Domain ID
Route label
APID
Storage system serial number
Number of the control unit to which the command device belongs
Command control address of the command device
Device number
Volume serial number
11).
Figure 85 (page 100)
Manage Route Panel (Route Management)
Type
Character string
Character string
Hexadecimal number
Character string
Hexadecimal number
Hexadecimal number
Hexadecimal number
Character string
to Figure 87 (page 100).
99