Pair Selection List (Primary) Panel - HP XP P9500 Reference Manual

Table 51 Contents of the Copy Group Pair Detail Panel (continued)
Item
CYL
You can use the LOCATE and SORT commands. For details about how to use each command, see
"Command Line Commands" (page
NOTE:
Even if you dissolve all of the copy pairs in a copy group, the copy group itself is not deleted.
To delete the copy group itself, the corresponding copy group ID must be deleted from the
Copy Group Selection List panel. If there is a copy group with no copy pairs, the copy group
operation results in an error.
When you enter an action in the AC column, complete the action by pressing the Enter key,
and then perform the next operation.
When an EXCTG attribute is defined, if you edit the copy pair definition in this panel, the
storage system information belonging to the copy group might change. Therefore, check the
definition of the EXCTG attribute in the Copy Group Detail Definition panel.
If the copy group is not a CG container, selecting Use Container and pressing the Enter key
returns the screen to the Copy Group Detail Definition panel. By doing this, you can change
the definition of the copy group from not being a CG container to being a CG container.

Pair Selection List (Primary) Panel

The Pair Selection List (Primary) panel is displayed in the following cases:
If the F5=Add key is pressed in the Copy Group Pair Detail panel, which causes the Pair
Selection List (Primary) panel to be displayed on top of the Copy Group Pair Detail panel.
If the F5=Prim key is pressed in the Pair Selection List (Secondary) panel, which causes the
Pair Selection List (Primary) panel to be displayed on top of the Pair Selection List (Secondary)
panel.
In the Pair Selection List (Primary) panel, you specify the P-VOL of the copy pair.
If you select Devn, enter the device range, and then press the Enter key, S is displayed next to the
AC of each device that falls within the range indicated by the starting and ending devices. If you
then press the Enter key with S displayed next to AC, the devices become selected. A similar
operation occurs when you select Volser and specify the devices by volume name.
Figure 71 (page 85)
84 ISPF Panels
Description
SSID Storage subsytem number
CU CU number
CCA The two leftmost characters indicate the CCA of the device in hexadecimal.
The rightmost character indicates, as follows, whether the CCA is an external
volume.
+: An external volume.
-: Not an external volume.
(blank): The volume attribute is unknown because it was not requested.
Displays the result of comparing the P-VOL and S-VOL capacities.
P: Displayed if the P-VOL capacity is larger than the S-VOL capacity
S: Displayed if the S-VOL capacity is larger than the P-VOL capacity
N/A: Displayed if the capacity of the P-VOL or SVOL or the capacities
of both the P-VOL and S-VOL cannot be obtained
(blank): Indicates that the capacity of the P-VOL and S-VOL are the same
shows the Pair Selection List (Primary) Panel.
11).