HP XP P9500 Reference Manual page 254

SVOL ({PROTECT|PERMIT})
Specify whether writing to the S-VOL is permitted or protected after a volume is suspended (SUSPOP).
When this parameter is not specified, the value specified in the ISPF panel is assumed. If the
ATTIME parameter or CANCEL parameter are both specified, this specification is disregarded,
and the write permissions for the S-VOL during the suspend are canged as follows, depending on
the copy type:
Copy type
Business Copy for Mainframe
Continuous Access Asynchronous for
Mainframe
PROTECT
This value means that writing to the S-VOL is protected after a volume is suspended (SUSPOP).
PERMIT
This value means that writing to the S-VOL is permitted after a volume is suspended (SUSPOP).
DEVN (p-vol-device-number,s-vol-device-number) ~ <4-digit hexadecimal
number, 4-digit hexadecimal number>
Specify the device number of the copy pair (P-VOL and S-VOL) to operate.
VOLUNIT
When this is specified, operation is performed by volume even when the environment supports
operation by group.
Usually, to operate by volume only those copy pairs whose statuses do not match due to such
reasons as failure, specify this along with the SELECT(COND) parameter.
SELECT({ALL|COND})
Specify the selection method for the copy pair to be manipulated by the command. When not
specified, ALL is assumed.
ALL
All the copy pairs in the copy group are to be manipulated by the command. Note that if the DEVN
parameter is specified, the copy pair specified for the parameter is the execution target of the
command.
COND
The pairs to be manipulated by the command depend on their volume status. For more information,
see the table describing the copy pair statuses that are subject to the command, in the HP P9000
for Business Continuity Manager Software Users Guide.
254 CLI Commands
Write permissions to the S-VOL
Writable
Not writable