Ykconmsg Command - HP XP P9500 Reference Manual

Table 97 YKBLDPTH Command Return Code List
Return Code
-4095 to -4040
-3
-1
0
32
36
40
44
48
128

YKCONMSG Command

Applies to Business Copy for Mainframe, Continuous Access Synchronous for Mainframe, Continuous
Access Synchronous for Mainframe with the HyperSwap attribute, and Continuous Access
Asynchronous for Mainframe.
Format
YKCONMSG
{ OP(OPEN) [
1
[ TIMEOUT(timeout-value)]|
1
OP(GET)
1 1
OP(CLOSE)
1
Function
This command is a TSO/E command called from REXX scripts.
This command monitors for the following messages:
IEA494I message
Copy status display message that is output to the MVS console
IOSHM0414I message
HyperSwap completion message that is output to the MVS console
User-specified message
User-specified message that indicates that a HyperSwap has been completed
Meaning
The command terminated abnormally, possibly because the user SVC routine has
not been included properly.
The module cannot be loaded. Possible causes are as follows:
The library dataset has not been linked.
The module is protected by the RACF program control function.
An interruption occurred during execution.
The command completed normally.
I/O errors were encountered. None or only some of the logical paths were
established.
A change to an I/O configuration definition was detected.
Processing was interrupted because a REXX variable with an invalid value was
encountered. No logical paths were established.
No path to be established was found.
An error occurred while a REXX variable was being read or written.
Command execution terminated abnormally due to insufficient capacity or some
other internal cause. None or only some of the logical paths were established.
Command execution terminated because of an invalid parameter. No logical paths
were established.
The command terminated abnormally. The user does not have permission to execute
this command.
MSGID({IEA494|IOSHM0414I|user-specified-message-ID})]
1
HANDLE(X'handle')|
HANDLE(X'handle')}
1
Command details 191