HP XP P9500 Reference Manual page 352

Item name
SSN
SCU
SCCA
CTID
SubCTID
Number-Of-Pairs
1
For details about data types, see the table of syntax elements in
Be Executed" (page
2
Use either of the following methods to specify P-VOL and S-VOL volumes:
Device number
Storage system serial number, CU number, and CCA number
If both methods are used, the device number specification takes precedence.
3
For only part of the specified number, the volumes that exist at consecutive addresses are defined as a copy pairs. The
definition depends on the P-VOL and S-VOL specification method:
When volumes are specified by the device number
Volumes with consecutive device numbers are defined as a copy pair.
When volumes are specified by the storage system serial, CU, and CCA numbers
Volumes with consecutive CU and CCA numbers are defined as a copy pair.
You must specify 1 even if you do not define copy pairs repeatedly. The following example shows
the copy group definition file that is displayed on the ISPF panel when the following information
is specified:
PDEVN: 731 1
SDEVN: 2A01
Number-Of-Pairs: 3
Information displayed on the ISPF panel
352 Data Objects
Value to be specified
Storage system serial
number of the secondary
2
site
CU number of the secondary
2
site
CCA number of the
2
secondary site
Consistency group ID
Subconsistency group ID
Number of times the
specified copy pair is to be
3
repeated
182).
1
Data type
Alphanumeric
Hexadecimal
Hexadecimal
Hexadecimal for other than
CAJ:
Specify in the range from 00
to 7F
For CAJ:
Specify in the range from 00
to FF.
Hexadecimal
Specify in the range from 00
to FF.
Decimal
Specify in the range from 1
to 99,999.
" Copy Types and Targets for Which Commands Can
Length (characters)
1 - 5
1 - 2
1 - 2
1 - 2
1 - 2
1 - 5