Ykqrypth Command - HP XP P9500 Reference Manual

parameter or the SN, CU, and CCA parameters belongs, and whose secondary storage system is
one that has the serial number specified by the SSN parameter. If this parameter is omitted, even
if the PATH parameter is specified, the command will only acquire inter-CU logical path information
(without acquiring inter-DKC logical path information).
SMODEL({USP|USPV|VSP})
To obtain information on an inter-DKC logical path, specify the model of the secondary storage
system for the inter-DKC logical path you want to obtain. If this parameter is omitted, USP is
assumed.
USP
Specify this option when the model of the secondary storage system for the inter-DKC logical path
you want to obtain is HP XP12000/XP10000 Disk Array.
USPV
Specify this option when the model of the secondary storage system for the inter-DKC logical path
you want to obtain is HP XP24000/XP20000 Disk Array.
VSP
Specify this option when the model of the secondary storage system for the inter-disk controller
logical path you want to obtain is VSP.
Return Codes
Table 1 19 (page 228)
Table 1 19 YKQRYDEV Command Return Code List
Return Code
-4095 to -4040
-3
-1
0
32
40
44
48
128

YKQRYPTH Command

Applies to PTH.
Format
YKQRYPTH
STEM(stem-name-1)
1
228 CLI Commands
lists the return codes to be returned when the YKQRYDEV command terminates.
Meaning
The command terminated abnormally, possibly because the user SVC routine has
not been included properly.
The module cannot be loaded. Possible causes are as follows:
The library dataset has not been linked.
The module is protected by the RACF program control function.
An interruption occurred during execution.
The command completed normally.
I/O errors were encountered.
A change in an I/O configuration definition was detected.
An error occurred while a REXX variable was being written.
Terminating due to processing errors.
Terminating due to invalid parameters.
The command terminated abnormally. The user does not have permission to execute
this command.