Setting Original(S) On The Platen - Olivetti d-Copia 52 Operation Manual

* When setting A3, Folio and B4 originals, open the ejection guide to avoid originals
from dropping.
* When copying duplex originals, originals will be ejected temporarily from the DF
original reversing cover for reversing. Do not touch the originals at this time. If the
originals are pulled out by force, the original misfeeds may occur.
G Auto selection mode
The size of each originals is detected to copy to the paper of the same size as each
original.
* Up to 50 sheets can be loaded in DF in this mode.
* A3 and A4 originals can be set in this mode and only the originals of the same
size in width can be used.
• How to set auto selection mode
Press the auto selection key on the operation panel to light the auto selection
indicator.

Setting original(s) on the platen

For original(s) that cannot be set in the DF, such as a book and magazine, open
the DF main body to set the original on the platen.
1. Hold the DF opening/closing lever to open the DF.
* When opening the DF, check if no original is on the original table and original
ejection cover. Otherwise, it may fall down when the DF is opened.
2. Set the original(s).
Face down the originals on the platen and align them with original size indicator.
3. Hold the DF opening/closing lever to close the DF.
* At this time, avoid pressing the platen excessively. The platen may be broken.
CAUTION
DO NOT leave the document feeder open as there is a danger of
personal injury.
SETTING ORIGINALS
16