Table of Contents
Advertisement
FUNCTIONS
33
5. Select the copying direction of the back side.
"LEFT": The back side is copied in the same direction as it is.
"TOP": The back side is copied by turning 180 degrees. Each two-page original is to
be copied in the same direction by binding the finished copies in the upper part.
Go to step 8.
6. Specify the type of original, by touching the "DUPLEX" or "BOOK" key.
* If "DUPLEX" is selected, go to step 8.
If "BOOK" is selected, go to next step.
7. Select the binding direction of book originals.
"LEFT": Two-page originals are copied from right side.
"RIGHT": Two-page originals are copied from left side.
Go to next step.
* When copy mode setting is completed, the display will change to the sheet insertion
mode setting screen. Set each mode in accordance with the following procedure.
* Each mode on the display can be combined. (page 31, "2 Combinations of modes")
Cover mode settings
8. Touch the "COVER" key.
9. Select the cover setting by touching the "2-SIDED" key, the "FRONT" key (copy only
on the front side) or the "BLANK" key.
* If "SPLIT" or "1-SIDED" was selected for finishing of copying in step 3, "2-SIDED"
cannot be selected in this procedure.
10. Touch the "BACK" key.
11. Select the back cover setting by touching the "FRONT" key (copy only on the front
side), "BLANK" key or "NO" key (no back cover is attached).
* When other modes are not set, go to step 19.
Insert mode settings
12. Touch the "INSERT" key.
13. Specify the type of insert sheet, by touching the "FR./BACK COPY", "FRONT COPY"
or "FR./BACK BLANK" key.
* If either of the other modes is not selected, go to step 15.
Chapter mode settings
14. Touch the "CHAPTER" key.
Go to next step.
Advertisement
Table of Contents
