Table of Contents
Advertisement
Message
"CALL FOR SERVICE."
"TIME FOR MAINTENANCE"
"MEMORY FULL."
"PAPER IN DRAWER NOT REGISTERED
SIZE. CHECK PAPER IN DRAWER."
"PAPER MISFEED."
"FINISHER IS OUT OF ORDER.
DETACH FINISHER."
"CHECK PAPER IN FINISHER.
INCOMPLETE COPIES INSIDE."
"FINISHER IS OUT OF ORDER. DETACH
FINISHER."
"INSTALL FINISHER."
"CLOSE COVER OF FINISHER."
"CHECK PAPER IN FINISHER.
INCOMPLETE COPIES INSIDE."
"STAPLER EMPTY. (FRONT)
ADD STAPLES."
"STAPLER EMPTY. (REAR)
ADD STAPLES."
"CANNOT STAPLE.
##:MAX. (STAPLE)"
"CANNOT STAPLE THIS PAPER SIZE."
"CANNOT PUNCH THIS PAPER SIZE."
"PUNCH HOLE CONTAINER FULL."
Open and close the front cover. If this message does not disappear, make a note
of the "C" and numbers appearing with it, turn the main switch OFF (O), and
contact your service representative.
Periodic maintenance is necessary to keep your copier in good condition. Contact
your service representative as soon as possible.
Memory is full. Select if print till the last page which has just read or clear all of the
data which has already been read. Copying or reading of another original cannot
be performed until one of these is selected.
The defaulted paper size is not the same as the paper in the drawer. Change the
paper size by using the default setting. Copying with the wrong default setting
may lead to the paper misfeeds.
If paper is misfed, the copier will stop, and the location of the misfeed will be
displayed in the message display. Remove the misfed paper with the main switch
ON ( ) in accordance with the procedure.
The finisher (optional) is not installed correctly. Install it securely.
Unfinished copies were ejected into the tray of finisher (optional) due to the
problem happened during copying. Check and remove those copies.
Copier is inoperable due to the problem of the finisher (optional). Contact your
service representative.
The number of sheets in the finisher (optional) exceeds the capacity. Remove
them.
Paper is misfed inside of the finisher (optional). See the finisher's instruction
handbook to remove paper.
There are no staples in the indicated location of the finisher (optional). See the
finisher's instruction handbook to load staples.
Stapling cannot be operated since the number of copies in the staple sort mode
has exceeded its maximum capacity. Press the Start key and cancel the staple
sort mode to restart copying operation.
Stapling and punching cannot be operated with small size paper like A5. See the
finisher's instruction handbook.
The punch waste tank of finisher (optional) is full of punch waste. See the
finisher's instruction handbook to remove the punch waste.
Action
MESSAGES
Page
___
___
___
78
86
___
___
___
___
___
___
___
___
___
84
Advertisement
Table of Contents
