Table of Contents
Advertisement
SETTING ORIGINALS
Setting original(s) in the DF
The copier is equipped with the DF (document feeder).
Multiple sheet originals loaded into the DF automatically fed one by one. The DF
automatically turns over duplex originals for copying on the reverse side.
Originals that can be loaded in the DF
• Sheets originals
• Thickness: One-sided originals: between 35 g/m
Duplex originals: between 50 g/m
• Size:
Max. A3 to Min. A5 (vertical)
• Capacity: 70 sheets (A4 or smaller size, 80 g/m
50 sheets (B4 or larger size, 80 g/m
(However, 50 sheets when using auto selection mode)
Notes
Do not use originals of the kinds listed below.
When using perforated sheets or sheets with punch holes, do not insert the end
with the perforations or holes first.
• Transparencies
• Carbon paper, crumpled originals, those with strong folds or soft originals such as
vinyl
• Originals which are not rectangular, wet originals, sheets with adhesive tape or
glue
• Original with clips or staples (To use such originals, remove clips or staples and
straighten the crumpled or folded originals before setting them.)
• Clipping or sheets with very slippery surfaces
• Originals with wet correcting fluid
• Originals with folds (When such originals must be used, smooth out the folded
portion before setting them.)
1. Adjust the original insert guides to fit the size of the original.
* Check if any ejected originals are left on the original ejection cover before
setting the originals. If any originals are left on the original ejection cover,
original misfeeds may occur.
2. Arrange the originals in order and set them face up (front face up for duplex
originals) on the original table. The original set indicator lights green. If the
indicator does not light, reset the originals.
* The originals must not exceed the scale pasted on the rear original insert guide. If
excessive originals are set, the original misfeeds may occur.
2
- 160 g/m
2
2
- 120 g/m
2
2
)
2
)
Advertisement
Table of Contents
