ABOUT 52 PPM COPIER
This chapter covers matters specifically for 52 ppm copier.
Please refer this chapter, as well as other chapters in the
instruction handbook, if you purchased a 52 ppm copier.
Names of parts for main body...........................................99
Management code ..........................................................101
Auto shut-off time............................................................101
Opening/closing the front cover ......................................101
Removal procedure of misfeed in duplex unit.................101
Specifications..................................................................103
1 Platen
(Set a book original or the like that cannot be set in the DF
on this.)
2 Original size indicator lines
(Be sure to align the original with these when setting the
original on the platen.)
3 Operation panel
(Operate to copy here.)
4 Stack bypass tray
(Load paper here when copying onto small-size paper or
colored paper.)
5 Insert guides
(Be sure to match the paper size when loading paper on
the stack bypass tray.)
6 Support guide
(Pull out when copying onto A4 (vertical) or larger paper.
7 Front cover
(Open to replace a toner cartridge or for misfeed removal.)
8 Right cover
(Open when paper misfeed occurs in the paper feed
section.)
9 Drawer 1
(Holds up to 550 sheets of standard paper.)
0 Length adjustment lever
! Width adjustment lever
99
Names of parts for main body
The illustration and the instruction described on page 7 and
page 8 are different for 52 ppm copier as follows.
@ Drawer 2
(Holds up to 550 sheets of standard paper.)
# Paper feed deck
(Holds up to 3,000 sheets of standard paper.)
$ Right deck cover
(Open when paper misfeed occurs.)
% DF original reversing cover
(Open when paper misfeeds in DF section.)
^ Original set indicator
(The original condition is displayed.
Green lights: The original is set. Copying will begin by
pressing the Start key.
Green blinks: The original is not set securely. Reset the
original.
Red blinks: Originals are misfed. Remove all misfed
originals in accordance with page 93.)
& Original insertion guide
(Set to match the size of the original when setting in the
DF.)
* Original table
(Set the DF original on this table.)
( DF opening/closing lever
(Hold when opening and closing the DF.)
) Original ejection cover
(The copied originals are stored here.)