Altigen AltiWare ACC 5.2 Administration Manual page 59

Parameter Description
3. (optional) From the Non members list, you may select an IP
4. Enter digits in the Dialed Number field and Translate To field.
5. The Manipulation option allows you to remove or add digits to
First Digit These define how the system responds to the first digit dialed by the
Assignment user. The drop-down list options for each digit are:
• Extension
• Trunk Access
• Feature Access
• Operator
• Invalid (no action)
• IP Trunk Access
• Route Access
Trunk Access
outside number. "9" is the default trunk access code.
If you have a more complicated dialing number and routing plan,
change "9" to the Route Access code and configure the
Outcall Routing table.
Feature Access
as part of feature access codes. In addition, you may also set 1- 9
or * to Feature Access. For example, if 7 is set to Feature Access,
Station Login (#27) can also be accessed using 727.
extension that the Extension Dialed Digit Translator will apply to.
You can apply the same Members to multiple locations. You may
also enable the Bypass Account Code option if Account Codes
are required.
In Figure 4, assuming the system is located in area code 510,
when an IP extension user in LA dials "911," AltiServ will
translate the digits into "919495550911." (9 = IP trunk access
code, 19495550911 = the emergency center in LA that covers
the remote IP phone user's area.)
a number dialed by the IP extension.
The most common situation requiring this option is to hop-off a
VoIP call from a remote system to a remote CO line.
Defines how to get a PSTN trunk line to dial an
–
– By default, # is set to Feature Access, which is used
AltiWare ACC 5.2 Administration Manual 47
Chapter 4: System Configuration