Altigen AltiWare ACC 5.2 Administration Manual page 234

Chapter 17: AltiGen IP Phone Configuration
This opens the AltiGen IP Phone Configuration window, where, after setting up an IP
extension, you can set parameters for the extension:
Figure 1. IP Phone Configuration window, General tab
The left side of the IP Phone Configuration window displays all the IP phone extensions
that have been set up in the system. The status "Inactive" means the Enable IP
Extension box is checked for this extension in the Extension Configuration window, but
there is no IP phone logged in to the extension. The extension may be a physical
extension using an analog phone, a MobileExt, or a virtual extension.
After creating the IP extensions, you can set the following parameters on the General
tab:
Parameter
General
Default
Trunk
Access
Code
222
AltiWare ACC 5.2 Administration Manual
Description
Lets you specify the IP address of the AltiServ system the IP
phone is connected to. The version of firmware associated with
the IP phone is automatically displayed in the Version field.
To protect the configuration on the IP phone, check the Enable
Configure Password check box and assign a numerical
password. When the user presses the Menu button on the IP
phone to access the phone configuration menu, the user will
need to enter the assigned password. You can use this check
box for two purposes:
• If you publish the configuration password to the user, only
the phone user would be able to change the phone
configuration.
• If you do not publish the configuration password, you can
block the phone user from changing the phone
configuration.
Lets you set the digit required to enable a user to return an
outside call from the Call Log. The default trunk access code
can be the route access code, if it is set in AltiWare
Administrator.