Configuring Static Remote Mep - Cisco Catalyst 4500 Series Configuration Manual

Chapter 63 Configuring Ethernet OAM and CFM

Configuring Static Remote MEP

To configure Ethernet CFM static remote MEP, perform this task:
Command
Step 1
configure terminal
Step 2
ethernet cfm domain domain-name level level-id
Step 3
service {ma-name | ma-number | vpn-id vpn}
{vlan vlan-id [direction down] | port}
Step 4
continuity-check
Step 5
mep mpid identifier
Step 6
continuity-check static rmep
Step 7
end
Step 8
show ethernet cfm maintenance-points remote
static
Step 9
show ethernet cfm errors [configuration]
Step 10
copy running-config startup-config
Use the no form of each command to remove a configuration or to return to the default settings.
The following example illustrates how to configure Ethernet CFM static remote MEP:
Switch(config)# ethernet cfm domain abc level 3
Switch(config-ecfm)# service test vlan 5
Switch(config-ecfm-srv)# continuity-check
Switch(config-ecfm-srv)# mep mpid 23
OL-25340-01
Purpose
Enter global configuration mode.
Define a CFM domain, set the domain level, and enter
ethernet-cfm configuration mode for the domain. The
maintenance level number range is 0 to 7.
Define a customer service maintenance association name
or number or a VPN ID to be associated with the domain,
and a VLAN ID or peer MEP, and enter
ethernet-cfm-service configuration mode.
ma-name—a string of no more than 100 characters that
•
identifies the MAID.
ma-number—a value from 0 to 65535.
•
vpn-id—enter a VPN ID as the ma-name.
•
vlan vlan-id—VLAN range is from 1 to 4094. You
•
cannot use the same VLAN ID for more than one
domain at the same level.
(Optional) direction down—specify the service
•
direction as down.
• port—Configure port MEP, a down MEP that is
untagged and not associated with a VLAN.
Enable sending and receiving of continuity check
messages.
Define the static remote maintenance end point identifier.
The range is 1 to 8191.
Enable checking of the incoming continuity check message
from a remote MEP that is configured in the MEP list.
Return to privileged EXEC mode.
Verify the configuration.
Enter this command after you enable CFM crosscheck to
display the results of the crosscheck operation. Enter the
configuration keyword to display the configuration error
list.
(Optional) Save your entries in the configuration file.
Software Configuration Guide—Release IOS XE 3.3.0SG and IOS 15.1(1)SG
Configuring Ethernet CFM
63-13