Configuring Etherchannels; Default Etherchannel Configuration - Cisco Catalyst 3750-E Software Configuration Manual

Chapter 38 Configuring EtherChannels and Link-State Tracking
For more information about switch stacks, see

Configuring EtherChannels

These sections contain this configuration information:
•
•
•
•
•
•
•
Make sure that the ports are correctly configured. For more information, see the
Note
Configuration Guidelines" section on page
Note After you configure an EtherChannel, configuration changes applied to the port-channel interface apply
to all the physical ports assigned to the port-channel interface, and configuration changes applied to the
physical port affect only the port where you apply the configuration.

Default EtherChannel Configuration

Table 38-3
Feature
Channel groups
Port-channel logical interface
PAgP mode
PAgP learn method
PAgP priority
LACP mode
LACP learn method
LACP port priority
LACP system priority
LACP system ID
Load-balancing
OL-9775-08
Default EtherChannel Configuration, page 38-11
EtherChannel Configuration Guidelines, page 38-12
Configuring Layer 2 EtherChannels, page 38-13
Configuring Layer 3 EtherChannels, page 38-15
Configuring EtherChannel Load-Balancing, page 38-18
Configuring the PAgP Learn Method and Priority, page 38-19
Configuring LACP Hot-Standby Ports, page 38-20
Default EtherChannel Configuration
Chapter 5, "Managing Switch Stacks."
(required)
(required)
(optional)
(optional)
38-12.
Default Setting
None assigned.
None defined.
No default.
Aggregate-port learning on all ports.
128 on all ports.
No default.
Aggregate-port learning on all ports.
32768 on all ports.
32768.
LACP system priority and the switch or stack MAC
address.
Load distribution on the switch is based on the
source-MAC address of the incoming packet.
Catalyst 3750-E and 3560-E Switch Software Configuration Guide
Configuring EtherChannels
(optional)
"EtherChannel
38-11