Show Lacp - Cisco 4500M Command Reference Manual

show lacp

show lacp
To display LACP information, use the show lacp command.
Syntax Description
channel-group
counters
internal
neighbors
sys-id
Defaults
This command has no default settings.
Command Modes
Privileged EXEC
Command History Release
12.1(13)EW
Usage Guidelines
This command is not supported on systems configured with a Supervisor Engine 1.
If you do not specify a channel-group value, all channel groups are displayed.
You can enter the optional channel-group value, to specify a channel group for all keywords, except the
sys-id keyword.
Examples
This example shows how to display LACP statistical information for a specific channel group:
Switch# show lacp 1 counters
Port
---------------------------------------------------
Channel group: 1
Fa4/1
Fa4/2
Fa4/3
Fa4/4
Switch#
The output displays the following information:
•
•
Catalyst4500 Series SwitchCiscoIOS Command Reference—Release 12.2(18)EW
2-332
show lacp [channel-group] {counters | internal | neighbors | sys-id}
(Optional) Number of the channel group; valid values are from 1 to 64.
Displays the LACP statistical information.
Displays the internal information.
Displays the neighbor information.
Displays the LACP system identification.
Modification
Support for this command was introduced on the Catalyst4500 series switches.
LACPDUs
Sent Recv
8 15
14 18
14 18
13 18
The LACPDUs Sent and Recv columns display the LACPDUs sent and received on each specific
interface.
The LACPDUs Pkts and Err columns display the marker protocol packets.
Chapter2 Cisco IOS Commands for the Catalyst 4500 Series Switches
Marker LACPDUs
Sent Recv Pkts Err
0 0 3 0
0 0 3 0
0 0 0
0 0 0
78-16201-01