Cisco 4500M Command Reference Manual page 424

show storm-control
This is an example of output from the show storm-control command for a specified interface and traffic
type, where no storm control threshold has been set for that traffic type on the specified interface.
Switch# show storm-control gigabitethernet2/1 broadcast
Interface
---------
Gi2/1
<output truncated>
Table2-18
Table2-18 show storm-control Field Descriptions
Field
Interface
Filter State
Level
Current
Related Commands
storm-control
show interfaces counters
show running-config
Catalyst4500 Series SwitchCiscoIOS Command Reference—Release 12.2(18)EW
2-392
Filter State Level
------------- -------
forwarding 100.00%
describes the fields in the show storm-control display.
Description
Displays the ID of the interface.
Displays the status of the filter:
•
Blocking—Storm control is enabled, and a storm has occurred.
•
Forwarding—Storm control is enabled, and no storms have occurred.
•
Inactive—Storm control is disabled.
Displays the threshold level set on the interface for broadcast traffic.
Displays the bandwidth utilization of broadcast traffic as a percentage of
total available bandwidth. This field is only valid when storm control is
enabled.
Note
N/A is displayed for interfaces that do storm control in hardware.
Chapter2 Cisco IOS Commands for the Catalyst 4500 Series Switches
Current
-------
N/A
78-16201-01