Show Diagnostic Result Module - Cisco 4500M Command Reference Manual

Chapter2 Cisco IOS Commands for the Catalyst 4500 Series Switches

show diagnostic result module

To display module-based diagnostic test results, use the show diagnostic result module command .
Syntax Description
slot-num
all
test
test-id
test-id-range
all
detail
Defaults
A summary of the test results for all modules in the chassis is displayed.
Command Modes
Privileged EXEC
Command History Release
12.2(18)EW
Examples
This example shows how to display the summary results for all modules in the chassis :
Switch# show diagnostic result module
Current bootup diagnostic level: minimal
module 1:
Overall diagnostic result: PASS
Diagnostic level at card bootup: bypass
Test results: (. = Pass, F = Fail, U = Untested)
module 4:
Overall diagnostic result: PASS
Diagnostic level at card bootup: minimal
Test results: (. = Pass, F = Fail, U = Untested)
78-16201-01
show diagnostic result module [slot-num | all] [test [test-id | test-id-range | all]] [detail]
(Optional) Specifies the slot on which diagnostics are displayed.
(Optional) Displays diagnostics for all slots.
(Optional) Displays selected tests on the specified module.
(Optional) Specifies a single test ID.
(Optional) Specifies a range of test IDs.
(Optional) Displays diagnostics for all tests.
(Optional) Displays complete test results.
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
1) supervisor-bootup -----------------------> U
2) packet-memory-bootup --------------------> U
3) packet-memory-ongoing -------------------> U
1) linecard-online-diag --------------------> .
Catalyst4500 Series SwitchCiscoIOS Command Reference—Release 12.2(18)EW
show diagnostic result module
2-247