Duplex - Cisco 4500M Command Reference Manual

Chapter2 Cisco IOS Commands for the Catalyst 4500 Series Switches

duplex

To configure the duplex operation on an interface, use the duplex command. To return to the default
setting, use the no form of this command.
Syntax Description
auto
full
half
Defaults
Half-duplex operation
Command Modes
Interface configuration
Command History Release
12.1(8a)EW
Usage Guidelines
Table2-2
Table2-2
Interface Type
10/100-Mbps module
100-Mbps fiber
modules
Gigabit Ethernet
Interface
10/100/1000
78-16201-01
duplex {auto | full | half}
no duplex
Specifies autonegotiation operation.
Specifies full-duplex operation.
Specifies half-duplex operation.
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
lists the supported command options by interface.
Supported duplex Command Options
Supported
Syntax
duplex [half |
full]
duplex [half |
full]
Not supported.
duplex [half |
full]
Catalyst4500 Series SwitchCiscoIOS Command Reference—Release 12.2(18)EW
Default Setting Guidelines
half If the speed is set to auto , you will
not be able to set the duplex mode.
If the speed is set to 10 or 100, and
you do not configure the duplex
setting, the duplex mode is set to half
duplex.
half
Not supported. Gigabit Ethernet interfaces are set to
full duplex.
If the speed is set to auto or 1000,
you will not be able to set duplex.
If the speed is set to 10 or 100, and
you do not configure the duplex
setting, the duplex mode is set to half
duplex.
duplex
2-93