Service-Policy - Cisco 4500M Command Reference Manual

Chapter2 Cisco IOS Commands for the Catalyst 4500 Series Switches

service-policy

To attach a policy map to an interface, use the service-policy command. To remove a policy map from
an interface, use the no form of this command.
Syntax Description
input
output
policy-map name
Defaults
A policy map is not attached to an interaface.
Command Modes
Interface configuration
Command History Release
12.1(8a)EW
Examples
This example shows how to attach a policy map to a Fast Ethernet interface:
Switch(config)# interface fastethernet 5/20
Switch(config-if)# service-policy input pmap1
Switch(config-if)#
Related Commands
class-map
policy-map
78-16201-01
service-policy {input | output} policy-map name
no service-policy {input | output} policy-map name
Specifies input policy maps.
Specifies output policy maps.
Name of a previously configured policy map.
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
Catalyst4500 Series SwitchCiscoIOS Command Reference—Release 12.2(18)EW
service-policy
2-235