System Access Configuration; Management Networks Configuration - HP 438031-B21 - 1:10Gb Ethernet BL-c Switch Cli Reference Manual

System Access configuration

The following table describes the System Access Configuration commands.
Table 92 System Access Configuration commands
Command
[no] access http enable
access http port <TCP port
number>
[no] access snmp {read-only|
read-write}
access telnet port <TCP port
number>
[no] access telnet enable
access tftp-port <TFTP port
number>
show access

Management Networks configuration

The following table describes the Management Networks Configuration commands. You can configure up
to 10 management networks on the HP 1:10GbE switch.
Table 93 Management Networks Configuration commands
Command
access management-network <IP
address> <IP mask>
no access management-network
<IP address> <IP mask>
show access management-network
Description
Enables or disables HTTP (Web) access to the Browser-based Interface. It
is enabled by default.
Command mode: Global configuration
Sets the switch port used for serving switch Web content. The default is
HTTP port 80.
Command mode: Global configuration
Disables or provides read-only/write-read SNMP access.
Command mode: Global configuration
Sets an optional telnet server port number for cases where the server
listens for telnet sessions on a non-standard port.
Command mode: Global configuration
Enables or disables Telnet access.
Command mode: Global configuration
Sets an optional telnet server port number for cases where the server
listens for TFTP sessions on a non-standard port.
Command mode: Global configuration
Displays the current system access parameters.
Command mode: All
Description
Adds a defined network through which switch access is allowed
through Telnet, SNMP, RIP, or the browser-based interface. A range of
IP addresses is produced when used with a network mask address.
Specify an IP address and mask address in dotted-decimal notation.
Command mode: Global configuration
Removes a defined network, which consists of a management network
address and a management network mask address.
Command mode: Global configuration
Displays the current management networks parameters.
Command mode: All except User EXEC
Configuration Commands
115