Operations-Level Port 802.1X Options; Operations-Level Vrrp Options - HP 438031-B21 - 1:10Gb Ethernet BL-c Switch Cli Reference Manual

Operations-level port 802.1x options

Operations-level port 802.1x options are used to temporarily set 802.1x parameters for a port.
Table 178 Operations-Level Port 802.1x commands
Command
interface port <port
number> dot1x init
interface port {<port
number>} dot1x re-
authenticate

Operations-level VRRP options

Operations-level VRRP options are described in the following table.
Table 179 Operations-Level VRRP commands
Command
router vrrp backup <1-256>
Description
Re-initializes the 802.1x access-control parameters for the port. The
following actions take place,
depending on the 802.1x port configuration:
force unauth—the port is placed in unauthorized state, and traffic is
blocked.
auto—the port is placed in unauthorized state, then authentication is
initiated.
force auth—the port is placed in authorized state, and authentication
is not required.
Command Mode: Privileged EXEC
Re-authenticates the supplicant (client) attached to the port. This command
only applies if the port's 802.1x mode is configured as auto.
Command Mode: Privileged EXEC
Description
Forces the specified master virtual router on this switch into backup mode.
This is generally used for passing master control back to a preferred switch
once the preferred switch has been returned to service after a failure. When
this command is executed, the current master gives up control and initiates a
new election by temporarily advertising its own priority level as 0 (lowest).
After the new election, the virtual router forced into backup mode by this
command will resume master control in the following cases:
This switch owns the virtual router (the IP addresses of the virtual router
and its IP interface are the same)
This switch's virtual router has a higher priority and preemption is
enabled.
There are no other virtual routers available to take master control.
Command Mode: Privileged EXEC
Operations Commands
178