Forwarding Database Configuration - HP 438031-B21 - 1:10Gb Ethernet BL-c Switch Cli Reference Manual

Table 110 Spanning Tree Port Configuration commands
Command
spanning-tree stp {<1-128>}
link {auto|p2p|shared}
[no] spanning-tree stp
{<1-128>} edge
spanning-tree stp {<1-128>}
fastforward
spanning-tree stp {<1-128>}
enable
no spanning-tree stp
{<1-128>} enable
show interface port {<port
number>} spanning-tree stp
{<1-128>}

Forwarding Database configuration

The following table describes the Forwarding Database Configuration commands.
Table 111 FDB Configuration commands
Command
aging <0-65535>
show mac-address-table
Description
Defines the type of link connected to the port, as follows:
auto—Configures the port to detect the link type, and automatically
match its settings.
p2p—Configures the port for Point-To-Point protocol.
shared—Configures the port to connect to a shared medium (usually
a hub).
This command only applies when RSTP is turned on. See the "Common
Internal Spanning Tree configuration" section for more information.
Command mode: Interface port
Enables or disables this port as an edge port. An edge port is not
connected to a bridge, and can begin forwarding traffic as soon as the
link is up. Configure server ports as edge ports (enabled).
This command only applies when RSTP is turned on. See the "Common
Internal Spanning Tree configuration" section for more information.
Command mode: Interface port
Enables or disables Port Fast Forward on the port.
Command mode: Interface port
Enables STP on the port.
Command mode: Interface port
Disables STP on the port.
Command mode: Interface port
Displays the current STP port parameters.
Command mode: All
Description
Configures the aging value for FDB entries, in seconds.
The default value is 300.
Displays current FDB parameters.
Configuration Commands
131