System Snmp Configuration - HP 438031-B21 - 1:10Gb Ethernet BL-c Switch Cli Reference Manual

Table 81 NTP Server Configuration commands
Command
ntp interval <1-44640>
ntp enable
no ntp enable
show ntp

System SNMP configuration

The switch software supports SNMP-based network management. In SNMP model of network
management, a management station (client/manager) accesses a set of variables known as
MIBs (Management Information Base) provided by the managed device (agent). If you are running an
SNMP network management station on your network, you can manage the switch using the following
standard SNMP MIBs:
MIB II (RFC 1213)
Ethernet MIB (RFC 1643)
Bridge MIB (RFC 1493)
An SNMP agent is a software process on the managed device that listens on UDP port 161 for SNMP
messages. Each SNMP message sent to the agent contains a list of management objects to retrieve or to
modify.
SNMP parameters that can be modified include:
System name
System location
System contact
Use of the SNMP system authentication trap function
Read community string
Write community string
The following table describes the System SNMP Configuration commands. The following sections provide
more detailed information and commands.
System SNMP Configuration commands
Table 82
Command
hostname <1-64 characters>
Description
Specifies the interval, in minutes (1-44640), to resynchronize the switch
clock with the NTP server. The default is 1440 seconds.
Command mode: Global configuration
Enables the NTP synchronization service.
Command mode: Global configuration
Disables the NTP synchronization service. This is the default.
Command mode: Global configuration
Displays the current NTP service settings.
Command mode: All
Description
Configures the name for the system. The name can have a maximum of
64 characters.
Command mode: Global configuration
Configuration Commands
106