Acl Port Configuration - HP 438031-B21 - 1:10Gb Ethernet BL-c Switch Cli Reference Manual

Table 98 Gigabit Link Configuration commands
Command
duplex {full|half|any}
flowcontrol
{receive|send|both}
no flowcontrol
[no] auto
show interface port
{<port number>}

ACL Port configuration

The following table describes the basic Access Control List Configuration commands for the port.
Table 99 ACL Port Configuration commands
Command
[no] access-control list <1-896>
[no] access-control group <1-896>
show interface port [<port number>]
access-control
Description
Sets the operating mode. Not all options are valid on all ports. The choices
include:
Full-duplex
Half-duplex
any for automatic detection (default)
NOTE: Ports 19-21 are set to full duplex, and cannot be changed.
Command mode: Interface port
Sets the flow control. The choices include:
Receive (rx) flow control
Send (tx) flow control
Both receive and transmit flow control (default)
Command mode: Interface port
Sets the flow control to none.
Command mode: Interface port
Enables or disables auto-negotiation for the port.
NOTE: Ports 19-21 are set to 10000 Mbps, and cannot be set to auto-negotiate.
Command mode: Interface port
Displays current port parameters.
Command mode: All
Description
Adds or removes the specified ACL.
Command mode: Interface port
Adds or removes the specified ACL Group.
Command mode: Interface port
Displays current ACL QoS parameters.
Command mode: All
Configuration Commands
120