HP 438031-B21 - 1:10Gb Ethernet BL-c Switch Cli Reference Manual page 103

Table 79 RADIUS Server Configuration commands
Command
[no] radius-server secondary-host
<IP address> key <1-32 characters>
radius-server port <UDP port
number>
radius-server retransmit <1-3>
radius-server timeout <1-10>
[no] radius-server telnet-backdoor
[no] radius-server secure-backdoor
radius-server enable
no radius-server enable
show radius-server
IMPORTANT: If RADIUS is enabled, you must login using RADIUS authentication when connecting
via the console or Telnet/SSH/HTTP/HTTPS. Backdoor for console is always enabled, so you can
connect using noradius and the administrator password even if the backdoor or secure backdoor
(secbd) are disabled.
If Telnet backdoor is enabled, type in noradius as a backdoor to bypass RADIUS checking, and
use the administrator password to log into the switch. The switch allows this even if RADIUS servers
are available.
If secure backdoor is enabled, type in noradius as a backdoor to bypass RADIUS checking, and
use the administrator password to log into the switch. The switch allows this only if RADIUS servers
are not available.
Description
Sets the secondary RADIUS server address and shared secret
between the switch and the RADIUS server(s).
Command mode: Global configuration
Enter the number of the User Datagram Protocol (UDP) port to be
configured, between 1500-3000. The default is 1645.
Command mode: Global configuration
Sets the number of failed authentication requests before switching
to a different RADIUS server. The range is 1-3 requests. The
default is 3 requests.
Command mode: Global configuration
Sets the amount of time, in seconds, before a RADIUS server
authentication attempt is considered to have failed. The range is
1-10 seconds. The default is 3 seconds.
Command mode: Global configuration
Enables or disables the RADIUS back door for
telnet/SSH/HTTP/HTTPS. This command does not apply when
secure backdoor is enabled.
Command mode: Global configuration
Enables or disables the RADIUS back door using secure password
for telnet/SSH/HTTP/HTTPS. This command does not apply when
backdoor (telnet) is enabled.
Command mode: Global configuration
Enables the RADIUS server.
Command mode: Global configuration
Disables the RADIUS server. This is the default.
Command mode: Global configuration
Displays the current RADIUS server parameters.
Command mode: All
Configuration Commands
103