Statistics Commands; Introduction - HP 438031-B21 - 1:10Gb Ethernet BL-c Switch Cli Reference Manual

Statistics Commands

Introduction

You can view switch performance statistics in the user, operator, and administrator command modes. This
chapter discusses how to use the ISCLI to display switch statistics.
The following table describes general Statistics commands.
Table 44 Statistics commands
Command
show layer3 counters
show snmp-server counters
show ntp counters
clear ntp
show ufd counters
show counters
Usage
Displays Layer 3 Statistics.
Command mode: All
Displays SNMP statistics.
Command mode: All
Displays Network Time Protocol (NTP) Statistics.
You can execute the clear command option to delete all statistics.
Command mode: All
Clears Network Time Protocol (NTP) Statistics.
Command mode: All
Displays Uplink Failure Detection statistics.
Command mode: All
Dumps all switch statistics. Use this command to gather data for tuning and
debugging switch performance. If you want to capture dump data to a file,
set your communication software on your workstation to capture session
data prior to issuing the dump command.
Command mode: All
Statistics Commands
66