HP 438031-B21 - 1:10Gb Ethernet BL-c Switch Cli Reference Manual page 122

802.1x Global Configuration commands
Table 102
Command
dot1x mode {[force-unauthorized|
auto|force-authorized]}
dot1x quiet-time {<0-65535>}
dot1x transmit-interval
{<1-65535>}
dot1x supplicant-timeout
{<1-65535>}
dot1x server-timeout {<1-65535>}
dot1x max-request {<1-10>}
dot1x re-authentication-interval
{<1-604800>}
[no] dot1x re-authenticate
default dot1x
show dot1x
Description
Sets the type of access control for all ports:
force-unauth—the port is unauthorized unconditionally.
auto—the port is unauthorized until it is successfully authorized
by the RADIUS server.
force-auth—the port is authorized unconditionally, allowing
all traffic.
The default value is force-auth.
Command mode: Global configuration
Sets the time, in seconds, the authenticator waits before transmitting
an EAP-Request/ Identity frame to the supplicant (client) after an
authentication failure in the previous round of authentication. The
default value is 60 seconds.
Command mode: Global configuration
Sets the time, in seconds, the authenticator waits for an EAP-
Response/Identity frame from the supplicant (client) before
retransmitting an EAP-Request/Identity frame. The default value is
30 seconds.
Command mode: Global configuration
Sets the time, in seconds, the authenticator waits for an EAP-
Response packet from the supplicant (client) before retransmitting
the EAP-Request packet from the authentication server. The default
value is 30 seconds.
Sets the time, in seconds, the authenticator waits for a response
from the Radius server before declaring an authentication timeout.
The default value is 30 seconds.
Command mode: Global configuration
Sets the maximum number of times the authenticator retransmits an
EAP-Request packet to the supplicant (client). The default value is 2.
Command mode: Global configuration
Sets the time, in seconds, the authenticator waits before re-
authenticating a supplicant (client) when periodic re-authentication
is enabled. The default value is 3600 seconds.
Command mode: Global configuration
Sets the re-authentication status to on or off. The default value is
off.
Command mode: Global configuration
Resets the global 802.1x parameters to their default values.
Command mode: Global configuration
Displays current global 802.1x parameters.
Command mode: All
Configuration Commands
122