Link to Disable configuration
The following table describes the Link to Disable (LtD) commands. The LtD can consist of any mix of
downlink ports (ports 1-16) and trunk groups that contain only downlink ports.
Link to Disable commands
Table 175
Command
ufd fdp ltd port <port number>
no ufd fdp ltd port <port number>
ufd fdp ltd portchannel <1-12>
no ufd fdp ltd portchannel <1-12>
ufd fdp ltd adminkey
<1-65535>
no ufd fdp ltd adminkey <1-65535>
Configuration Dump
The dump program writes the current switch configuration to the terminal screen. To start the dump
program, at the prompt, enter:
Switch(config)# show running-config
The configuration is displayed with parameters that have been changed from the default values. The
screen display can be captured, edited, and placed in a script file, which can be used to configure other
switches. Paste the configuration commands from the script file at the command line prompt of the switch.
The active configuration can also be saved or loaded via FTP/TFTP.
Configuration Commands
Description
Adds a port to the current LtD group. Only downlink
ports (1-16) are allowed in the LtD.
Command mode: Global configuration
Removes a port from the current LtD group.
Command mode: Global configuration
Adds a trunk group to the current LtD group. LtD trunk
groups can contain only downlink ports (1-16).
Command mode: Global configuration
Removes a trunk group from the current LtD group.
Command mode: Global configuration
Adds a LACP admin key to the LtD. LACP trunks formed
with this admin key will be included in the LtD.
Command mode: Global configuration
Removes a LACP admin key from the LtD.
Command mode: Global configuration
175