Removing a compression card
To remove a compression card, complete the following steps.
1. Read the safety information that begins on page vii and "Installation guidelines"
2. If the blade workstation is installed in a BladeCenter unit, remove it (see
3. Remove the blade workstation cover (see "Removing the blade workstation
4. Pivot the end of the card out of the compression-card connector; then, slide the
5. If you are instructed to return the compression card, follow all packaging
26
BladeCenter HC10 Type 7996: Problem Determination and Service Guide
Compression card
on page 13.
"Removing the blade workstation from a BladeCenter unit" on page 16).
cover" on page 19 for instructions).
card out of the compression-card bracket and lift the card out of the blade
workstation.
instructions, and use any packaging materials for shipping that are supplied to
you.