Installing a compression card
To install a compression card, complete the following steps.
1. Touch the static-protective package that contains the compression card to any
2. Orient the compression card over the system board.
3. Slide the end of the card into the raised compression-card bracket; then, gently
4. Install the blade workstation cover (see "Installing the blade workstation cover"
5. Install the blade workstation into the BladeCenter unit (see "Installing the blade
Compression card
unpainted metal surface on the BladeCenter unit or any unpainted metal surface
on any other grounded rack component; then, remove the compression card
from the package.
pivot the card into the compression-card connector.
on page 20).
workstation in a BladeCenter unit" on page 17).
Chapter 4. Removing and replacing blade workstation components
27