Table of Contents
Advertisement
Removing the blade workstation from a BladeCenter unit
Attention:
v To maintain proper system cooling, do not operate the BladeCenter unit without a
v Note the bay number. Reinstalling a blade workstation into a different bay than
To remove the blade workstation from a BladeCenter unit, complete the following
steps. The appearance of your BladeCenter unit might be different, see the
documentation for your BladeCenter unit for additional information.
Release handles
(open)
1. Read the safety information that begins on page vii and "Installation guidelines"
2. (BladeCenter T and HT units only) Remove the bezel assembly on the
3. If the blade workstation is operating, shut down the operating system; then,
4. Pull the two release handles to the open position as shown in the illustration.
5. Pull the blade workstation out of the bay.
6. Place either a blade filler or another blade workstation in the bay within 1
16
BladeCenter HC10 Type 7996: Problem Determination and Service Guide
blade workstation, blade server, expansion unit, or blade filler installed in each
blade bay.
the one from which it was removed could have unintended consequences. Some
configuration information and update options are established according to bay
number; if you reinstall the blade workstation into a different bay, you might have
to reconfigure the blade workstation.
on page 13.
BladeCenter T or HT unit. For detailed instructions for removing the bezel
assembly, see the Installation and User's Guide that comes with the
BladeCenter T or HT unit.
press the power-control button (behind the blade workstation control panel door)
to turn off the blade workstation (see "Turning off the blade workstation" on
page 6 for more information).
Attention:
Wait at least 30 seconds, until the hard disk drives stop spinning,
before proceeding to the next step.
The blade workstation moves out of the bay approximately 0.6 cm (0.25 inch).
minute.
Advertisement
Table of Contents
