Installing a graphics card
To install a replacement graphics card, complete the following steps.
1. Touch the static-protective package that contains the expansion card to any
2. Orient the graphics card over the system board and slide the narrow end of the
3. Lower the release latch to secure the graphics card to the system board.
4. Install the blade workstation cover (see "Installing the blade workstation cover"
5. Install the blade workstation into the BladeCenter unit (see "Installing the blade
Graphics
card
Release
latch
unpainted metal surface on the BladeCenter unit or any unpainted metal surface
on any other grounded rack component; then, remove the expansion card from
the package.
card into the graphics-card connector.
Note: For device-driver and configuration information to complete the
installation of the graphics card, see the documentation that comes with
the graphics card.
on page 20).
workstation in a BladeCenter unit" on page 17).
Chapter 4. Removing and replacing blade workstation components
29