Table of Contents
Advertisement
Removing the battery
To remove the battery, complete the following steps.
1. Read the safety information that begins on page vii and "Installation guidelines"
2. If the blade workstation is installed in a BladeCenter unit, remove it (see
3. Remove the blade workstation cover (see "Removing the blade workstation
4. Locate the battery on the system board (see "System board connectors" on
5. Use one finger to press the top of the battery clip away from the battery. The
6. Use your thumb and index finger to lift the battery from the socket.
7. Dispose of the battery as required by local ordinances or regulations.
Installing the battery
The following notes describe information that you must consider when you are
replacing the battery in the blade workstation.
v When you are replacing the battery, you must replace it with a lithium battery of
v To order replacement batteries, call 1-800-426-7378 within the United States, and
v After you replace the battery, you must reconfigure the workstation and reset the
v To avoid possible danger, read and follow the following safety statement.
30
BladeCenter HC10 Type 7996: Problem Determination and Service Guide
on page 13
"Removing the blade workstation from a BladeCenter unit" on page 16 for
instructions).
cover" on page 19 for instructions).
page 7 for instructions).
battery pops up when released.
Note: See "Battery return program" on page 89 for more information.
the same type from the same manufacturer.
1-800-465-7999 or 1-800-465-6666 within Canada. Outside the U.S. and
Canada, call your IBM marketing representative or authorized reseller.
system date and time.
Advertisement
Table of Contents
