Removing and replacing Tier 1 CRUs
Replacement of Tier 1 CRUs is your responsibility. If IBM installs a Tier 1 CRU at
your request, you will be charged for the installation.
The illustrations in this document might differ slightly from your hardware.
Removing the blade workstation cover
To remove the blade workstation cover, complete the following steps.
Cover
pins
1. Read the safety information that begins on page vii and "Installation guidelines"
2. If the blade workstation is installed in a BladeCenter unit, remove it (see
3. Carefully lay the blade workstation down on a flat, static-protective surface, with
4. Press the blade-cover release on each side of the blade workstation or
5. Lift the cover from the blade workstation and store it for future use.
Blade-cover
release
on page 13.
"Removing the blade workstation from a BladeCenter unit" on page 16 for
instructions).
the cover side up.
expansion unit and lift the cover open, as shown in the illustration.
Chapter 4. Removing and replacing blade workstation components
Blade-cover
release
19