Table of Contents
Advertisement
Installing a SATA storage drive
To install a SATA storage drive, complete the following steps.
Hard disk drive
release lever
1. Identify the location where the SATA storage drive will be installed.
2. Touch the static-protective package that contains the hard disk drive to any
3. Place the drive into the drive tray and push it toward the rear of the drive tray.
4. Install the blade workstation cover (see "Installing the blade workstation cover"
5. Install the blade workstation into the BladeCenter unit (see "Installing the blade
Hard
disk drive
unpainted metal surface on the BladeCenter unit or any unpainted metal surface
on any other grounded rack component; then, remove the hard disk drive from
the package.
Attention:
Do not press on the top of the drive. Pressing the top might
damage the drive.
The drive slides into the connector until the drive moves past the lever at the
front of the tray.
on page 20 for instructions).
workstation in a BladeCenter unit" on page 17 for instructions).
Chapter 4. Removing and replacing blade workstation components
23
Advertisement
Table of Contents
