IBM HC10 - BladeCenter - 7996 Service Manual page 88

v Follow the suggested actions in the order in which they are listed in the Action column until the problem
is solved.
v See Chapter 3, "Parts listing, Type 7996," on page 11 to determine which components are CRUs and which
components are FRUs.
v If an action step is preceded by "(Trained service technician only)," that step must be performed only by a
trained service technician.
Error code Description
110-600-001 I/O and Graphics Adapter: Failed
110-4xx-yyy I/O and Graphics Adapter: Aborted
165-060-000 Service Processor: ASM may be busy
165-198-000 Service Processor: Aborted
165-201-000 Service Processor: Failed
72
BladeCenter HC10 Type 7996: Problem Determination and Service Guide
Action
1. Turn off the blade workstation and reseat the
blade workstation in the chassis.
2. Update the BMC firmware.
3. Reseat the compression card.
4. Replace the following components one at a time,
in the order shown, restarting the blade
workstation each time:
a. Compression card
b. (Trained service technician only) System
board assembly
1. Turn off the blade workstation and reseat the
blade workstation in the chassis.
2. Update the BMC firmware.
3. Reseat the compression card.
4. Replace the following components one at a time,
in the order shown, restarting the blade
workstation each time:
a. Compression card
b. (Trained service technician only) System
board assembly
1. Rerun the diagnostics test.
2. Correct other error conditions that might be
keeping the Advanced System Management
(ASM) network or components busy. See the
error log and diagnostic panel.
3. Turn off the blade workstation and reseat it in the
BladeCenter unit.
4. (Trained service technician only) Replace the
system board assembly.
1. Rerun the diagnostics test.
2. Correct other error conditions that might be
keeping the Advanced System Management
(ASM) network or components busy. See the
error log and diagnostic panel.
3. Turn off the blade workstation and reseat it in the
BladeCenter unit.
4. (Trained service technician only) Replace the
system board assembly.
1. Power down blade workstation and reseat it in the
chassis.
2. (Trained service technician only) Replace the
system board assembly.