Processor Card; Removing The Processor Card - IBM RS/6000 44P 170 Installation Manual

Processor Card

Before performing these procedures, read "Safety Notices" on page vii. Use the
following steps when removing or installing the processor card.

Removing the Processor Card

Attention: Your system unit may require updating the firmware. A diskette or CD-ROM
1. Shut down the system as described in "Stopping the System Unit" on page 22.
2. Unplug the power cable.
3. Remove the left side cover described in "Removing the Left Side Cover" on
page 23.
4. Remove the cover support bridge as described in "Removing the Cover Support
Bridge" on page 26.
5. Unplug the power connector (P11) from the processor card connector (J8).
6. Pull up on the two snap buttons located on each side of the processor card.
34
44P Series Model 170 Installation Guide
is included with your new processor card if that is required. Refer to
"System Firmware Updates" on page 51.
Snap Button Snap Button