Loading Paper; Loading Paper Into Tray 1 (Tandem Tray) - Ricoh 9100DN - Aficio SP B/W Laser Printer Hardware Manual

Loading Paper

The following section explains how to load paper when paper runs out.
• When loading paper, take care not to trap or injure your fingers.

Loading Paper into Tray 1 (Tandem Tray)

The following explains the procedure for loading paper into Tray 1.
The paper trays are set by the manufacturer to accommodate the following types of paper:
Default settings
Tray 1: A4
1
Tray 1: 11 × 8 /
2
• When paper loaded in the right side of Tray 1 runs out, paper on the left is automatically shifted to
the right. While the paper is moving, a message instructing you to wait appears. Do not pull out the
tray at this time.
• For the right stack, align the right edge of the paper with the right edge of the tray. For the left stack,
align the left edge of the paper to the left edge of the tray.
• Tray 1 uses A4 paper. If you want to load paper other than A4 paper, contact your service
representative.
• Do not stack paper over the limit mark.
1. Carefully pull out the paper tray until it stops.
2. Square the paper, and then place it print side down.
ANS051S
Loading Paper
6
63