Ricoh 9100DN - Aficio SP B/W Laser Printer Hardware Manual page 98

9. Troubleshooting
The printer is out of the staple.
• Add staples, cancel staples mode or cancel the job.
• See p.81 .
Add staples (Booklet)
Both staplers of the Booklet Finisher is out of staples.
• Add staples to the both staplers of the Booklet Finisher.
• See p.81 .
• Alternatively, cancel the staple mode using [Form Feed], or cancel the job.
Add staples (Booklet: Back)
The back stapler of the Booklet Finisher is out of staples.
• Add staples to the back stapler of the Booklet Finisher.
• See p.81 .
• Alternatively, cancel the staple mode using [Form Feed], or cancel the job.
Add staple (Booklet: Front)
The front stapler of the Booklet Finisher is out of staples.
• Add staples to the front stapler of the Booklet Finisher.
• See p.81 .
• Alternatively, cancel the staple mode using [Form Feed], or cancel the job.
Add Toner
The printer is out of toner.
9
• Replace the toner bottle.
• See p.81 .
Call Service: EC Power Off On/Call Service if error reoccurs
A communication error was sent from the engine to the controller.
• Turn the power switch to Standby, and then to ON. If the message appears again, call your sales /
service representative.
Cannot check Signal in Ad hoc
An attempt to check the radio signal was made while the communication mode was set to [802.11 Ad
hoc] in the [Maintenance] menu.
• To check the radio signal, select Infrastructure in the communication mode settings.
Cannot duplex Tray #
The selected tray is set to 1 sided tray when duplex mode is set.
96