Removing Jammed Staples; Finisher Sr841 - Ricoh 9100DN - Aficio SP B/W Laser Printer Hardware Manual
Operating instructions
Hide thumbs
Also See for 9100DN - Aficio SP B/W Laser Printer:
- Brochure & specs (4 pages) ,
- Software manual (344 pages)
Table of Contents
Advertisement
9. Troubleshooting
Removing Jammed Staples
• Keep your hands clear of the booklet finisher tray when pulling out or pushing in the finisher's staple
unit. You can trap your fingers if you do not.
If the "Add staples" message appears, when there are some more staples are left, or if your documents are
not stapled at all despite being set for staples, staple jams might have occurred.
• Staples might be jammed because of curled paper. In this case, try turning the paper over in the tray.
• After removing the jammed staples, staples might not be ejected for the first few times.
Finisher SR841
The following procedure explains how to remove jammed staples from the Finisher SR841.
1.
Open the finisher's front cover.
2.
Pull the lever R7 to slide out the unit, and then pull the lever R8 to slide out the staple unit.
9
3.
Turn the knob R9 to adjust to the scale.
116
AST115S
AST120S
Advertisement
Table of Contents
Troubleshooting
