Ricoh 9100DN - Aficio SP B/W Laser Printer Hardware Manual page 101

Hardware Problem Parallel I/F
The printer identified a parallel interface error.
• Turn the power switch to Standby, and then to On.
• Also, check the correct interface cable being used.
• If the message appears again, call your service provider.
Hardware Problem Printer font
The printer identified a printer font file error.
• It is necessary to replace the print module.
Hardware Problem Staple Unit
The Staple Unit is not functioning.
• Call your service provider.
Hardware Problem USB
The printer identified a USB I/F Board error.
• Turn the power switch to Stand by, and then to On. If the message appears again, call your service
provider.
Hardware Problem Wireless Board
Access to the IEEE 802.11b board is possible, but an error was detected.
• Check that the board is installed correctly. If the message appears again, call your sales / service
representative.
Invalid Password Try again
The invalid password was entered and Locked Print is incorrect.
• Enter the correct password.
Load Paper Tray # / Paper Size: Paper type:
No paper remaining in the indicated tray.
• Load the indicated tray with the paper or select another tray using [Form Feed], or cancel the job.
Load Paper: Tray # or Form Feed
The printer detected that the actual paper type and size in all trays were not the same as the paper tray
size and paper type setting when the Auto Paper Select mode is selected.
• Load the tray with the correct paper or change the paper type/size using the dial or using the Paper
Input menu on the control panel. Alternatively, select another tray using [Form Feed], or cancel the
job.
Low Toner remaining
The printer is almost out of toner.
Error & Status Messages on the Display Panel
9
99