3. Connecting the Printer
Network Connection
The following explains the procedure for connecting the printer to the computer through the network.Prepare
the hub and other network devices before connecting the 10BASE-T or 100BASE-TX cable to the printer's
Ethernet port. Alternatively, the optional gigabit ethernet board, which supports 1000BASE-T, is available.
• Use shielded Ethernet cable. Unshielded cables create electromagnetic interference that could cause
malfunctions.
• The Ethernet cable is not supplied with this printer. Select your cable according to the network envi-
ronment.
1.
Attach one ferrite core at the printer end of the Ethernet cable, and then attach the other
ferrite core about 10 cm (4 inches) (1) from this core making two loops as shown.
2.
Connect the Ethernet cable to the Ethernet port.
3.
Connect the other end of the cable to the printer's network, such as a hub.
• Follow the same procedure for the gigabit Ethernet cable.
AQU130S
AST012S
3
35